Overview:
This module is based on the original imported stepper motor drive chip THB6128 design, can drive 57 and the following two-phase four-wire stepper motor.
Feature:
- Chip using double full-bridge MOSFET driver, low on-resistance Ron = 0.55Ω
- Maximum voltage 36V, peak current 2.2A, continuous current 2A, the current set by DIP switch simple set
- 8-step subdivision (1/2/4/8/16/32/64/128) a variety of sub-optional, subdivided through the DIP switch to set
- Chip with automatic half-flow lock function, greatly reduce the heat when the motor is locked
- Chip built-in temperature protection, over-current protection
- Built-in 5V logic signal supply regulator chip, and add a current limiting resistor to reduce the chip fever when the input high voltage
- Input voltage side reverse polarity protection
- A power indicator, set aside 4 bolt holes, easy to install
Specifications:
Input voltage: DC 9V ~ 36V
Input current: 0.01A ~ 2.2A
Output current: 0A ~ 2.2A
Working temperature: -20 ~ 60℃
Storage temperature: -40 ° ~ 80 ℃
Size: 6.2x4.5cm/2.44x1.77inch
Operating humidity: no condensation, no water droplets
Gas environment: Prohibition of combustible gases and conductive dust
Package Included:
1 x Motor Driver Module
THB6128 Stepper Motor Driver Controller 128 Current Subdivision 2A Driver Board DC 9V-36V See detail